Recent content by briceandy4

I am looking at installing racedeck flooring in my garage and I was wondering if anyone had any information on coloring. I have a three car garage and I’m looking to install the garage flow on the 2 car side (wife side) and the circle trac on the single car (my side). The garage flow is...

I have really been looking into these lights because I like the look. After reading through some of the other posts I’m thinking I may go another route. The light output and coverage looks great but I feel for less money I could get similar coverage. While I feel (personal opinion) that they...

The 36” that someone told you was probably for working clearances. In your case this shouldn’t be an issue. Just place the disconnect in a readily accessible location and you should be good.

Working on finishing my three car garage. It has been an awfully slow process but today I was mudding and sanding my drywall.

Without having my code book in front of me I can’t say for sure if it would be code compliant with the LB but I know it will be tough to work the wires in there. If you’re able to pull the LB and replace it with a larger pull box like a 12x12 it will be more than enough room and will make your...

I will have to look at the code book and check wire fill. That seems like it would be a bit tight to me. One of the biggest problems will be that LB. Wire fill for condulets is actually pretty low. I would check and see if it is stamped with the volume. Other than that I would suggest using a...

Just looking though this thread and your garage turned out great. I know it’s the little things that go unnoticed by most but your electrician did a great job trimming out that panel. Very clean work.

If you are just looking for a box to mount the switch in a bell box would be the most common. There are many different options for switches as well. https://www.homedepot.com/p/BELL-N3R-Aluminum-Gray-1-Gang-Weatherproof-Outdoor-Electrical-Box-5-Outlets-at-1-2-in-With-2-Closure-Plugs-5323-0/204208013