Recent content by bruejones1

I still won't raise so I just parked it in the corner of my shop and I bought a different jack...I will look into the Weaver later...I suspect the release valve is the culprit though!

I did the air bleed procedure and saddle still pumps up on the downstroke and falls back down on the upstroke. Maybe something with the check balls? I put in the small one then the ball weight thing and then the big ball and put on the cap with a new gasket (steel ring).

No i didn't

I got my jack all put together but when I try to pump it up it goes up a little and comes right back down. I checked the needle valve on the release and adjusted it correctly and no jack oil is leaking anywhere. Any ideas guys?

oh sorry the release needle valve o rings

How do you get to the release o-rings to replace them. All I can see on mine is a brass washer thing in the hole and I cant remove it. update!the brass housing was stuck and got it out to put in the 2 orings!