Recent content by buck50

Correct, I will be pulling the wheel down so it lifts the coop. Here’s a quick mock up of it without the rest of the frame.

Yes, that clamp will be the mounting point.

I will have slack in the cable and with this there would not be any way to keep the cable on when I try to apply the wheel to the ground. This will be setting in some pretty rough pasture so I want something that encases the cable.

Yes, I could make my own bracket but I’m looking for something that is readily available/easy to repeat for others. I could also add a piece of angle to mount the pulley I have now but I’m trying to limit the list of materials.

I’m trying to bring an arm down that has a wheel mounted to it on a mobile chicken coop (chicken tractor). I need to be able to mount the pulley onto a chainlink fence end clamp since I am using chainlink top rails as my framing material. On top is the end clamp and the bottom is a 1.5” wall...

The issue with this one would be the angle I need to run the cable through. It would bind against the frame of that pulley.

A 1” wall/ceiling mount pulley would have a 1” diameter wheel/sheave with a slightly wider mount frame/bracket. This is a diagram of a 2” so it has a 2” sheave and a 2.5” mounting bracket.

I'm guessing the diameter of the pulley can be 1" because the 1.5" wall mount one has a mounting bracket that is just over 2".

My mounting surface is just under 2" wide so a 1" wall mount pulley would fit where the 1.5" mount is too wide.

I didn't see any that would because I need them to mount to the side similar to what I've drawn here.

I did a quick search and there are a lot of different options but I didn't see any that would be a side/wall mount.

The sliding door pulleys look like they mount to the floor/ceiling or top/bottom and I need one that mounts to the wall/side.

Probably around 100lbs. I see the 1-1/2 inch pulleys are rated for around 400lbs so a standard duty 1 inch would probably work.

Although they have a great selection I don’t see any on their site.

Does anyone know where I can buy 1" wall mount pulleys? The 1-1/2 are available everywhere but for whatever reason I can’t find any 1” ones. Something similar to this but one inch. https://www.zoro.com/zoro-select-wallceiling-mount-pulley-zinc-1rct1/i/G0424076/