Buckaroo5's latest activity
-
BBuckaroo5 replied to the thread Electric Garage Heater.I have a King Electric 5,000 watt 240V Eco 2s from Menards in my 3 bay insulated attached garage. I use it to take the edge off when I...
-
BBuckaroo5 replied to the thread Tolerance on 5.5mm Hex Impact Bit Socket.The 6mm fit in fine with a little wiggle (no hammering required) - it's so much easier when you know it's supposed to fit! It busted...
-
BBuckaroo5 reacted to Wrench97's post in the thread Tolerance on 5.5mm Hex Impact Bit Socket with
Like.
That RBRT stuff is a life saver on small headed fasteners be it hex torx or tripple square. -
BBuckaroo5 reacted to KnurledNut's post in the thread Tolerance on 5.5mm Hex Impact Bit Socket with Like.
Those are 6mm and can put up a pretty good fight. I have used a standard length 3/8 drive Snap-on bit socket successfully where cheaper...
-
BBuckaroo5 replied to the thread Tolerance on 5.5mm Hex Impact Bit Socket.Guys, thank you. This is what happens when you don't do your homework. I will report back....hope to make the 6mm fit.
-
BBuckaroo5 replied to the thread Tolerance on 5.5mm Hex Impact Bit Socket.Yes...that one.
-
BBuckaroo5 replied to the thread Tolerance on 5.5mm Hex Impact Bit Socket.Well, I may have hosed it up. I was looking at a youtube and it said it was a 5.5mm but the FSM says 6mm. I tried my 6mm after the 5.5...
-
BBuckaroo5 replied to the thread Tolerance on 5.5mm Hex Impact Bit Socket.It's a Toyota so metric but I am going to verity the size again in the FSM.
-
BBuckaroo5 replied to the thread Tolerance on 5.5mm Hex Impact Bit Socket.Thank you, that is a good option. It is a 1/4' drive and I would rather have a 3/8" drive and I don't think they have one. This is a...
-
BBuckaroo5 replied to the thread Tolerance on 5.5mm Hex Impact Bit Socket.Having a hard time finding anything beside Texton. I have an old Craftsman set with a 5 and a 6 but need the 5.5. I see a K-Tool...
-
BI just bought this socket from Texton and it is slipping in the fastener...
-
BBuckaroo5 reacted to pcmeiners's post in the thread Mini split install -- EPA certification required or not? with Like.
Even with these statements many manufacturers will warranty IF one follows state regulations and have EPA certification, some states do...
-
BBlueDriver offers a lot for the money.
-
BBuckaroo5 replied to the thread Mini split install -- EPA certification required or not?.You do not need the EPA Section 608 Certification to "legally" install a mini-split. You need it to buy bulk quantities of refrigerant...
-
BBuckaroo5 reacted to Beerhippie's post in the thread Recommend me a buy it for life and hand it down screwdriver set with Like.
Screwdrivers. regardless the quality, are consumables--they wear out. If you don't use them enough to wear them out, then any will do...