Recent content by budvanbeer1
-
B
Ideal wire wheel size for tough rust on car underbody?
For the heavier scaly rust and to get into the "nooks & crannies" I suggest a needle scaler. (Use the PPE you mentioned above PLUS some ear plugs or ear muffs or BOTH!!) Remember with a wire wheel you may remove a top lay but you're polishing the remaining rust not eliminating it. Coat you...- budvanbeer1
- Post #23
- Forum: General Tool Discussion
-
B
12" Craftsman Bandsaw
This post is a bit old I hope the two principles are still around or maybe someone else could help me...I picked up a used Craftsman 12" Band Saw via an online ad it worked for a short while 3 small jobs. After that I started it it ran for less than 1/2 minute and the blade stopped and a...- budvanbeer1
- Post #8
- Forum: General Tool Discussion
-
B
Foam insulation board attic
Machsnell, I just noticed your location. Are you getting the 3" panels in MD by any chance?- budvanbeer1
- Post #8
- Forum: Heating and A/C
-
B
Foam insulation board attic
"...My idea was to screw them to the underside of the trusses in the attic..." This would create an insulation ceiling, right?- budvanbeer1
- Post #3
- Forum: Heating and A/C