Recent content by bugzilla46310

  1. B

    let's see your craftsman block grinders

    Did you get the water trough? If not, https://www.facebook.com/share/14Zta5pFzdf/
  2. B

    Slowing down my drill press

    Any problem maintaining belt tension?
  3. B

    Let's Hear it for the Old Gray/Red Sears Craftsman Tool Chests and Cabinets (60s/70s)

    The tags are classic. I still have one of those label makers and some tape laying around somewhere. The Brother label maker has replaced it.
  4. B

    Greasing a grinder

    I put Lucas red and tacky in most everything around the house. When I replaced brushes on my 40+ year old 4” Makita angle grinder a few years ago, greased the gears on it also. Wouldn’t over analyze, though I often do!
  5. B

    How crazy is moving a custom built carport?

    Kinda already mentioned. Ask the neighbor if you can buy that small triangle of land, pay for a new survey and give your neighbor a case of his favorite afterwards.
  6. B

    Freshening up oil and grease soaked workbench

    All that time getting the oil off the top only to cover it with oil again. Oh the irony! 😂
  7. B

    1940's Kalamazoo P-series/816 bandsaw and gearbox question

    Thanks for the prompt reply. I don’t recall running past that spec sheet you posted.
  8. B

    1940's Kalamazoo P-series/816 bandsaw and gearbox question

    I also have a Kalamazoo 816 for about 20 years now. Works great but I decided to do some maintenance. Mine came with a single 2” pulley on the motor and the largest pulley on the gearbox is damaged. I’m looking for 5 pieces of information that I cannot find. 1-Gearbox ratio. With this I can...
  9. B

    The repurposing thread

    That’s awesome! Years ago when they were retiring a coal fired generating station where I worked, there was a phone similar to the one on the left in your picture, on an upper floor atop the coal bunkers. Needless to say, someone else snatched that up before I could get to it. But I did get a...
  10. B

    1920-60s DELTA / ROCKWELL picture thread - Post your Delta!

    I believe the stand is a Delta as it matches my 10” tilting table saw my dad bought used after WWII. There were no additional non OEM holes drilled in the stand and I kept it that way. The grinder was in similar condition. The bolts are unique as they are formed to match the depressions in the...
  11. B

    The repurposing thread

    Love the phones on the wall!
  12. B

    Hanging pliers on pegboard

    I hang my pliers behind the screwdrivers, which for me the screwdrivers would be in the circular holders where you have the T handles. Make those holders do double duty. I do not like the holders where you have the screwdrivers, as I inadvertently always knock them off.
  13. B

    Vintage Brown Brockmeyer bench grinder

    How about a picture of where the rubber feet were. A Dremel tool with the right bit and some patience should get the broken screws out.
  14. B

    Show off your woodworking

    FIFY
  15. B

    Here's The Dumbest Question Placed on GJ

    If it’s not a 3 way switch, up is usually on, down is usually off.
See more
Top Bottom