Recent content by bullhurly

Up above, is a picture of the area where the epoxy lifted while he was scraping the paint chips. He said it wasn't a big deal and that he will fix it tomorrow. I'm a little worried that if that lifted, more might lift later on. I don't know a whole lot about epoxy flooring, so perhaps you guys...

He did give me a warranty, but the job is still ongoing. He has to come back tomorrow morning, fix a few areas (area where it lifted included), then lay the last clear coat on. I believe he said it as a Polyaspartic clear coat. Can anyone tell me about the Amerlock epoxy he used? Is it a pretty...

He put down one of the clear coats today.. I wonder if he will be able to scrape without screwing it up?

He used a diamond grinder, although I noticed he didn't go all the way out to the edge of the concrete. At least, it looked like he stopped about an inch away...

Also, he used Amerlock Epoxy 400. Is this stuff considered to be pretty good quality?

I have a professional installing my epoxy. Today, he went to scrape the painted chips, and near the edge of the garage, some epoxy lifted and left about a quarter sized amount of exposed concrete. He used some technical jargon as to why this happened, but said he would fix it. My question is...