Recent content by Bunbun

Thank you sir!!

New guys on the block here... not sure what all this means, but doesn’t sounds to promising.

Didn’t even notice that...ATTENTION to details!!!

So the wire behind the walls should be good?

Thanks all for the response. I am looking to run a millermatic 211 and from the website: Input:16.6 A 50/60 hz single phase Output: 150A at 215 VDC, 40% duty cycle. Im hoping it’s just a simple outlet swap.

I ask my builder to add an outlet for me to run a welder (that I haven’t purchased yet) and I see this outlet..? Haven’t seen one like this before. I do know it an 30amp circuit and I think it’s 220v. My question is, if the male plus doesn’t align with the wall receptacle can I just replace the...