Recent content by burlijohnson

Wow Marlin, that's a really great point. I never knew that or thought about that! So you run the tool, and while it's run, you make sure there is 90PSI AT THE TOOL? My hose is a 50FT long 3/8" hose, with quick disconnects at both ends of the hose.

My max PSI is around 150PSI but I guess since the tool is recommended to be used at 90, I never really went any further. Regardless, it was working fine at 90 for a while now.

Oh okay! Thanks for all the replies guys! My hose is always in the bed of my truck so I wouldn't be surprised if it has rust in there somewhere. I will check that out and let you know. Thanks again!

It didn't sound or feel any different, which was the weird part. And it was not slower either.

The compressor is a gas-powered emglo that puts out about 11CFM @ 90PSI. There is no air dryer on the compressor. I normally just put a few drops of oil in the gun each time before I use it.

Hey guys, I have recently purchased a used 2135tiMAX. I have used it numerous times without a problem, but yesterday when I was trying to take off my pickup's tires, it would not remove any of the bolts. My compressor was strong enough, air supply was good, but I just wasn't getting any...