Burt Shaver's latest activity

Liquid Nitrogen, my Dermatologist has it in a Spray Can will chill the shaft nicely. Warm the bearing on the Incandescent Light Bulb...

My mistake, I said caliper when I meant to say outside micrometers.

And with good reason, anyone who is boarding or finishing will just about be worn out with bad shoulders in their forties. For some...

So I just got an email back from the EBay seller. It looks like he’s going to refund my money for the kit I ordered. I’m pretty happy...

My 2 Mitutoyo calipers that I purchased new came with a rod each, but the Starret outiside micrmetere u bought at the flea market did...

How often do you travel to your shop, if you calculated in your fuel, wear and tear on your vehicle plus your time traveling has value...

I want a private firearms range. Can't safely do that on the four acres. I have a membership at a range, but I want to be the sole range...

I think I could be more accurate with a dial bore guage and then use the outside micrometers to measure that reading. I think the inside...

Incredibly too small

Just to be clear. I’m asking everyone here. I know I’ve gotten the answer to this already but that sleeves ID was to small correct?

Nice, I usually turn on a little space heater I have in my shop, set the bearing in front of the space heater for half an hour or so...

For what it's worth, this is an example of a low budget bearing heater. 10 minutes is usually enough to expand the inner race to either...

https://www.ebay.ca/itm/135550357373

In this case, 28 to 31mm

-This is ok for checking most fastener sizes, I do with one of my calipers too. It's about HOW precise you need to be. -I have to...