Recent content by busch308

Go grab one from Harbor Freight and give it a shot. If you don't like it then you only spent a few bucks. I have a 1/4 HF and it works just the same as a Snap On. I did put a hard handle on it though.

I was able to dredge these up. I may have some more like them but they're on another computer. Maybe later.

I received a 3/8 kit from them just a few months ago. Minimal hassle. Give them a call, you'll probably have it by Monday.

Does anyone have a an easy blueing compound or technique they use on tools? I have several tools with industrial finishes that I've rescued from rust that could use a new finish.

Are the selectors on these chrome plated? They look unfinished in the photo's I've seen.

Very nice. I never find sets of SK, just odds and ends everywhere.

Here's something stumping me since I started getting into vintage Craftsman (aka the gateway drug of tools). The earliest metric sockets I've been able to find are -VV- and some -V-. No =V= at all. Are they just super rare and hard to find or do they exist at all? Looking at the code list...