bwringer's latest activity

FINALLY, we can kink shame

Contractors who... showed up? And did stuff? What sorcery is this???

Finally getting my Escape Room.

I’m not sure that you are using the right tool for the job. Having owned a fab shop for many years I had to have a lot of guys...

I have that tool and it’s one of my favorites. I suspect you are burying the wheel in the cut, where a small degree of misalignment...

Now you have 2.... As Mike said it doesn't seem to work.

You'd have to remove a LOOOOT of metal to significantly clean up most of the corners, and there are large areas on the sides that are...

A friend came by my house to give me a hand wit a few things, while we were in the garage he saw my anvil and we started talking about...

It looks like the previous owner used a hot/cold cut-off tool directly on the anvil. If you do that, you get those cuts in the surface...

I can hardly believe it! After 2 years of screwing around my building permit was approved today!

Because some people can't stand anyone being happy with a HF tool, and need to point out where they went wrong.

I bet this is going to be a great step up. Enjoy!