Recent content by C6Z

Very satisfied with my XPR-10A. I'm lucky, I had the room to set it up in the wide configuration and I'm glad I did. It makes getting in and out of the cars a snap. It's low enough for my Corvette, and the included adapters were tall enough for my Suburban (now sold). It just works.

Re: Would You Believe it an Oil Forum? Great site. That's where I learned about Terry Dyson.

Thanks all for the replies.

I'm digging through the archives about lifts, but I have a couple of questions that I haven't seen touched on. Maybe because they're too dumb. :) Here goes: I'm looking only at 2-post lifts. If I sometimes want to lift the car facing "backwards", meaning, I back the car into the lift bay...

Thanks all for the replies. As it turns out, I can't really make any significant changes with this builder anyways. It'll have to wait until after move-in.

We're thinking about having a new production house built. It would have a 3-car garage, plus a 12x16 "tandem" bay that would be used as a workshop. I want to be able to run a lift or maybe two, an air compressor, the usual. Nothing too heavy or fancy. Maybe a small MIG, or a small milling...