Recent content by Caddybill

I got mine

https://jawco.com/collections/flexible-shaft-tools-and-extensions I bought everything on sale.

I have to remove the fuel injectors on my 3.8l town and country in order to replace the o rings. While i'm at it i figured i will clean them. What the preferred way to clean them while i have them out? Something like this?

Neiko 1/4 impact for the service van.

I love this set, but the case is garbage. The cover broke the first time I took it out of the house.

A friend got to pick a deceased customers tools and gave me this.

I had to look that one up. Unbelievable, and I thought all this time it was because I had bootleg Chinese matches. I use wooden matches every day to check spillage and rollout on gas fired equipment. I light them with a lighter and wind up have to relight 3 to 4 times.

Not 100% sure. Saw a few pictures on line and all have the same as I have except for a swivel joint I am missing. Also mine has 2 spark plug sockets and all other pictures I saw have only 1.

Thanks. I did feal like it was a realy good deal

Got both of these $50. Chas Parker 975 and almost complete SK 1/4 & 3/8 set.

Mine were the cheep CENTRAL PNEUMATIC.

I had problems with the female ends. They did not slways seal tight, and eventually all leaked. Changed them all to milton. No problems with the male ends.

Very nicer. I would have a hard time justifying replacing the boiler if the rest of it looks good. The big difference in the new units are the safeties but those can be added to an old unit. Would be a good idea to have a combustion analysis done. And have gas valve pressure set properly. You...

check your voltage at the outlet. for the last 2 weeks my power company has been lowering our voltage to 100 to 102 volts. I could not use my air compressor last week. every time it started it tripped the breaker.

Supplyhouse.com