Recent content by Cajundude

Hell yea, glad you put that in my head now. My creeper has flames on it as well. Lol. Now back to the question, I got to knock it out right after I finished putting the new VCT floor in. So your answer is, put a new floor in, break the floor in, and in the middle of the break in, pull out...

You know when you walk into a school or a Wally World or whatever that has VCT there is alway a very thick shiny polish on top that is thicker than and covers up the seems? Almost like a very thick clear coat. What is that and where can I get some? BTW, garage pics are here. :beer:

Home depot has the black ones for sure. Keep in mind, these are white with speckles and the black also has speckles. If you want to order solids they are special order only and are twice as much.

My baby is almost ready to go into its new home. Not like some of the stuff I've seen here but I don't think it is too bad for my first time with just about all of this stuff. :beer: See It Here

I am redoing my garage right now and am wondering if I can run 6 flourescent four tube strips and two ceiling fans on one circuit. That circuit being the new line I ran to 7 additional outlets in the garage. The original plugs that I ran the wire for would probably only be used one at a time...

Thanks! You wanna know the worst part? We just moved into this house and I decided to finish the garage out before unpacking tools and stuff. Insulation, sheetrock, the whole 9 yards. Now for the worst part...I can't do my awaiting mods until I get this done. Cartek clutch kit and a STS...

What's up Evil! Good to see you on this board as well as CF. I've purchased all the materials to do my garage but am wondering, did you start from dead center or where? Thanks! :beer: