Recent content by calimander

Heres my 3/8” version

Early Cornwall 3/8 fine tooth rachet

Knipex cable cutters are really great for those hardened wires. Sent from my iPhone using Tapatalk

RedMax all the way!---- Researched the hell out of it. It is heavier than the stihl, but you won't have to wear It as long to get the job done. Sent from my iPad using Tapatalk

If you have internet access from a ethernet cable or are within wireless distance from a router you can't get any better than a internet radio. Thousands of stations and many with no commercials. I have been using a Grace Digital receiver in my shop hooked up to some bookshelf speakers and...

I'll have to dig out the 2"x72" stainless 1.5 hp DC one I made a few years ago .---I don't use it much anymore Sent from my iPad using Tapatalk HD

Thanks for the compliment. The sander that you made is awesome as well. I admire the clean lines and well thought out design. These little sanders are so handy I find myself using it all the time.I also like the low speed torque from the DC setup. I designed mine so It can be taken outside so I...

-Motor RPM -----0-2500+ -Hard rubber 4" drive wheel---off of a caster -All parts were made or customized except the 1/3 hp 90V DC Baldor motor, the KBC drive board and the idler roll bearings

Roughly based on a Kalamazoo, but made of stainless steel

Homemade 1x42 with a variable speed DC drive

Has anyone ever seen another? It has 5" jaws. It was painted puke green and looked to be a school vise. It took some doing to remove that tapered pin. Glad to see there is a forum for us guys with a vise vice. Sent from my iPad using Tapatalk HD

Hollands #45. Weighs110 lbs