Recent content by Cameo

All the time. I spend 3 hours in the garage to do a 5 minute job. the rest of the time is looking for that thing I just set down. then I buy a new one the next day, and **** there it is. most recent a 7/16 proto combo. last month. Found it 15 minutes after I got home with the new.

If you have a trailer hitch on both vehicles, drill a 2-1/4" ish centered hole in either end of a short 2x6 have the vehicles back to back, and drop the board over the balls. Push the dead one up the hill by backing up. Sounds like it wouldn't work, but I have pushed a dead extended cab ford...

Stacey David Quick tips Nylon fishing line through the nut a couple times on a jam nut should work.

Enerpac uses a very high pressure system, 5000 psi + on the Porta power. most of the run of the mill cylinders will be rated at 2500 psi. The pressure setting is the issue with the QDs as well. That's why you may have a problem matching them up with other's like SPX, Monarch etc

For garden tractor mountedsnowblowers,are they belt driven? I'd like to modify one to out to the front of my quad and drive it with a 8-12 hp engine. Anyone done this yet?

Quick ties I thin is the name of the the rope staps I have and love. 1/4&3/8" rope

Wow. I just finished reading this whole thread. I'll ta a break and cruse GJ for a bit before I check out your fairlane build. I, like everyone else, need to thank you for your help and inspiration for my future projects. Very well written and presented. Kyle is a lucky kid

I stumbled on this forum about a month ago, and tripped on this thread today. Read through it (most) and wow. I need to do a lot of work in my garage. I thought of myself as a master storage shelf builder, but no matter how tidy shelves are, they look like a mess. Doors are the way to go. and...