Recent content by CanyonRider

  1. C

    Project "Hot Rod Lincoln" (24 Hours of Lemons Build)

    I heard there was another car build going on. Very cool as usual! The old Nissan was a hoot to drive - no doubt this one will be also. I may have to drop in and check it out. CR
  2. C

    Converting Horse Barn to Shop

    Thanks for the input, folks! Yeah - Good point. The grade around the barn slopes down about 20+ inches from the back left corner to the front right corner (referring to the pic). The top of the piers and the existing dirt floor is only a couple inches above the existing grade at the back...
  3. C

    Converting Horse Barn to Shop

    Hey Y'all! Long-time lurker/learner and infrequent poster. I've done lots of searching and have seen many builds and projects, but as we all know, each one is different. So I thought I'd share my project (with pictures) with the collective and see what suggestions percolate. The Barn I have a...
  4. C

    ASTRO GIVEAWAY - 40SLMAX, Nano Max, and Nano Sockets

    Thanks for the give-away! Where do you buy your tools? Amazon Harry Epstein Zoro Tooltopia Thanks! CR
  5. C

    Lift Table & Vise - My Solution

    Thanks! You are close - its a Cagiva Gran Canyon. CR
  6. C

    Lift Table & Vise - My Solution

    I've always wanted a lift table for working on bikes, but have no space in the garage. I am fortunate to have a 4-post lift so I figured - surely I can figure out a way to use it. So I slid the ramps together, set the bike on it and stood back and thought. I wanted a wheel vise, but it had...
  7. C

    Building a motorcycle lift (platform) to be used with a 2 post lift

    Awesome project. I'm working on something similar - I'll share when I get it worked out. I noticed we run exactly the same tires - only I have an extra set of wheels. :-) Again, thanks for sharing! CR
  8. C

    Hitch Riser

    RoadMaster makes them up to 10" and good for 10,000lbs Here You'll need a different receiver hitch on your vehicle. CR
  9. C

    Modifying compressor tank top plate?

    Not exactly the same thing, but when my old tank rusted out, I cut the mounting plate off it and welded it on top of the plate on the new tank. Everything bolted right back up as before. CR
  10. C

    oscillating multi tool

    I recently picked this one up. http://www.amazon.com/gp/product/B00IC8FD4U?psc=1&redirect=true&ref_=oh_aui_detailpage_o00_s00 Awesome price, plenty of power - can't believe I've lived without it. Bonus, most people can't borrow it because they don't have an air compressor. :thumbup: CR
See more
Top Bottom