Recent content by Cap'nJake

I like gearwrench and the price difference isn't much per ratchet if you buy the sets. The 4 piece 120xp set is 125 and some change on amazon. Comes out to a little more than 30 dollars per ratchet. Which isn't a bad price at all.

I use cordless as much as possible so when I need a tool I don't have to wonder if I am close to an outlet or a hose.

Harbor freight also makes a 26 in tool box top and bottom chest are sold together. 16 drawers total if I remember right. Friend of mine has one and it isn't too bad.

People using my tools is a pet peeve of mine. There are a couple of people that I allow to use them but most people it's a big fat heck no. Especially after I caught my plant manager using one of my chrome deep sockets on an impact.

Yes it skips 27

Got a new Dewalt cordless 1/2 drive high torque impact and the Gearwrench shallow socket sets in both standard and metric. Gotta say I am impressed. The sockets seem to be terrific quality and the impact... well I didn't slow it down at all taking lug nuts off an f350 and did the axle nut off...

I almost bought them but went with the gearwrench set instead

I think the gearwrench impacts are rebadged cleco's and are less expensive

I use the HF one everyday. It's actually really good.

I wish I had the same setup as Adam Savage from mythbusters but that would cost a fortune There is a video on YouTube where he shows off his fastener collection it's truly impressive

This is perfect thank you!

Didn't mean to post the same picture 2x lol

Does anybody make one of these in 3/4 drive?

I don't need anything that big and welding isn't an option. It's not really a nut. It's actually a hex shaped die holder on a press.

Not a ton of torque usually not more than 50 to 80 lbs at the most. Who makes a 1-3/4 half inch drive socket tho. I have seen only up to 1-1/2 inch