Recent content by CaptNemo

  1. C

    Motion sensor in garage

    Why not just get a "Clapper" ?? :lol_hitti :shocking:
  2. C

    What did it cost for your detatched?

    With my shop being wiped out in Hurricane Katrina, I just got a copy of the insurance adjustment. They appraised a 24 X 24 that had to have a 75' + tall tree that's over 5' in iameter removed from the roof, then demo the building, haul off the debris and then rebuild it with insulation...
  3. C

    Any HVAC guys in here ??

    A big Thank You to Rickairmedic for helping me out on this.
  4. C

    Any HVAC guys in here ??

    I got it up and temporarily working yesterday, it looks like the PCB in the outdoor unit wnt kaput as well. I had to run the coil on the reversing valve off of the 24 volt terminals on the contactor, but it's working now. I'll need to order the outside PCB this next week, I wanted to be sure I...
  5. C

    Any HVAC guys in here ??

    Ok, the new board is in and all of the connections EXCEPT the thermostat wiring. I want to isolate / eliminate the Fuel Master Board but I see that the new PCB doesn't have the number of connections that the Heat pump and thermostat have. I realize that some of the wires will be doubled up on...
  6. C

    Any HVAC guys in here ??

    Thanks !!
  7. C

    Any HVAC guys in here ??

    I'm having trouble with one of the Heat pump / gas furnace / AC units in the house. The numbskulls that installed them several years ago decided to use me as a guinea pig for a Lennox "Fuel Master 21" control unit. Apparently, this unit wiped out one of my printed circuit boards and the A/C is...
  8. C

    New Guy...

    What's "Frost" ??? I live in Mobile, Alabama, on the Gulf Coast. The original slab is about even with the natural ground elevation. There is maybe +1/4" of elevation from the shop floor elevation to the driveway elevation. Pretty close, and no accounting for drainage. It was a bady designed...
  9. C

    New Guy...

    I don't want to raise the deck that much, I need to be able to roll equipment ( engine hoists, engine stands, TIG welding Machine, etc. ) in and out of the main doors without too much incline. I figured the 4" dimension would be a good compromise between flooding resistance and workability. If...
  10. C

    New Guy...

    MY 24 X 24 shop is a total after Hurricane Katrina. I have a huge sycamore tree through the roof of the shop and it's begun to collapse the structure. The insurance adjuster has been here and I'm waiting for a settlement check, so i'ts not all out of pocket. The vast majority of the contents of...
Top Bottom