Recent content by Cardinal Flyer

Thanks for the suggestion Johnny! My slab runs between 5 & 6" so I was hoping someone might have tried pulling instead of pounding. I'm thinking pulling might be less work since most of the anchors are already somewhat loose. But if I don't find a way to pull them I guess it'll be Sledge Hammer...

Help: Want to Switch from "Dry" to Epoxy Anchors Have had my lift installed for just over a year, and like most here absolutely love it! HOWEVER, I must have done a poor job drilling the anchor holes as but 3 anchors require constant re-torquing, and 1 anchor will no longer torque to specs. So...

Re: New Install: Went Up; Won't Come Down. HELP! If I run the motor to pump up the pressure in the system, I'll get air when I crack the bleeder valve. As soon as I hit the down valve handle I hear the air pressure release, but the lift heads do not go down. If I then crack the bleeder valves...

Re: New Install: Went Up; Won't Come Down. HELP! No typo: I needed almost 12 qts before the motor pumped up the lift. So the "drain" valve must not be opening and allowing the lift to lower. Something's weird here as I read several posts where guys ran 40+ feet of hose and didn't have this...

New Install: Went Up; Won't Come Down. HELP! Thanks to all the great posts here and in the original MaxJax thread my install seemed to be going flawlessly! Even rigged 36' hose through overhead PVC to keep the floor open (though I assume that's why I needed 12 quarts of hyd fluid to fill the...