Recent content by cartoonz

Well, just got off the phone with Snap-On support. 4 new drawer slide sets on both sides & cover stops for the lid are on their way ...under warranty, no return necessary. it may have helped that I told her she was a "Goddess of efficiency", seems I was the first pleasant customer she's had so...

No, it doesn't rock...just slides out of position a bit. 1/8" board?

Cool, thanks. I'll look again, but it isn't where it "should be" so far.. Another question... The top box tends to want to slide around a bit if you roll the whole thing around. There doesn't seem to be any holes that match between the two for a guide pin or the like. Is there some tricks or...

I'll be damned if I can find a serial number anywhere on the thing though. Is there a secret spot on these? No, it is not on the back lower right...

5 would be fantastic, but I can likely get away with just one set, or even just one (R). The KR637 has really old sliders. They are the same as the 8-2488ALRS sliders in the lower cabinet, but they are completely unmarked other than (L) or (R). One of the right ones in the top box...

Thanks... are there any other sources or alternatives for the 8-2488ALRS drawer slides other than Snap-On at ~$80/pair?

I recently bought everything from a retiring body man. This is the box, full of tools too ;) Now I'm trying to rehab the upper chest and I can't seem to figure out exactly what the model is on it. Here's a pic, anyone know what model this setup is, especially the upper box...