Recent content by CCash

I carry a small selection of bits for my fastback knife, and driver in a flexable (squeeze to open) old school coin holder in my pocket, as well as some change. That helps to keep them somewhat corralled 🤣

Let me if I can help here without completely confusing things. I have a Load Pro, and wanted to have a similar tester (something that "loads" a circuit) as a spare in my truck, so I built one out of a Bosch relay. The easy way to build a circuit to test is use your 9v battery (I used a 12v...

Looks like the die part of a key-way cutting broaching set. The corresponding part (not shown) looks like a file with large teeth on the side. It's used for cutting a key-way inside of a round hole like a pulley or gear. The little knob on the side opposite of the opening is for holding and...

Nicely done. Check with your local building inspector, but you might be able to bolt steel flitch plates to both sides of those sistered 2x10s. The inspector could get you started on the thickness required. This would allow you to space the posts out. Or, Place your benches in that area...