cgrutt's latest activity

Just wanted to let folks know I finished the adapter cable. I took two plugs, and spliced things together, making sure wires were...

The US military was at the show! I just sent an email to vendor will see what they say. Hopefully will correct for future shows. I...

Town put on a 250th event couple days ago. West Point band followed by a drone show. All and all it was a pretty good show but I was...

I just got a project to do kitchens and baths in a couple of apartments that a friend recently bought. The apartments are in an older...

Funny the garage door opener that I repaired was an Access Master but believe its made by Lift Master. Different control board though...

@cgrutt - Funny you mentioned door opener. Not all that long ago, I replaced two cpas on my Liftmaster control. Posted about it here...

Are you saying the replacement cap caused your control board to fail or that the run cap was not the issue? I recently went through...

I usually run a bit of denatured alcohol through pump and hoses of brake bleeder and also in oil pans after using them.

Bottom roller at about 30 seconds Click on the "watch on You Tube" link

Nice call on Wudel. There is write-up here...

Those jacks were made by the Wudel company...1000lb rating. Model 700. I bought one new in 1972...was $250.00. Still use it today...

Same spec made in different facilities could just be how tooling in facility was configured. Film windings may be short and wide in one...

Does trailer have electric brakes or need auxiliary power? Is it a camper? I'd leave it and buy an adapter...

Recently bought a motive pressure bleeder and it says the cap that I bought for my Ford will work...

Well the roof will support at least 260 lbs.