Recent content by Chefjpd

Is there a tool to prevent soap accidents?

The angle head pliers posts made me curious. Bit the bullet and purchased my first Austrian tool. Super high quality fit and finish. Now looking for something to use it on........ And fittingly used my metric tape measure from Paris.

Still not over in the USA. I went to a civil war fort in North Carolina a few years ago. I love history. The US Department of Parks guide called it " the war of northern aggression" Ok, being a yankee, I just said " alrighty then"

Ill be here all week......

Excellent detective skills, I stand corrected and humbled...

Wrong... Quote from the first post: 4 Ton Capacity Per Stand - Always use in pairs Flat Top Rubber Grips at Lifting Point Sold in Pairs Stable Triangular Base Powdercoat Finish on Base Min Height 13.8" Max Height 21.81" Capacity: 4 Tons per stand - always use in pairs

All depends upon where the exhaust vent is for the hood. If it is next to your window, you might be sucking in exhaust back into the room.

Commercial kitchen return air is a mixed blessing. One restaurant I worked had an induction grill that got stupid hot (800 plus degrees) The return air system had ambient air from outside feeding it. SO, In the winter I had 800* in my face and 30* air blowing down my back. Fun times, I'm lucky...

Don't forget about Quiet. Some less expensive models sound like jet engines.

I'm getting mine tomorrow, Ill give you a comparison to my Knipex.

It absolutely destroyed the a anodizing on one of my AllClad pots. My wife thought it needed a strong cleaning. Well, now I have a bare aluminum exterior on said pot. (Was $300 when purchased)