Recent content by chevouier

Thanks looking into to some shops over here but for now I'll keep practicing enjoying these sites everyone so helpful cheers mark Sent from my SM-G900I using Tapatalk

Thanks I'll keep practicing good luck with ya shop wish I was over your side of the world haven't found anything like that in new Zealand cheers mark Sent from my SM-G900I using Tapatalk

getting better what ya think Sent from my SM-G900I using Tapatalk

Thanks again for your help I'll keep practicing and will post my results enjoy your work amazing Sent from my SM-G900I using Tapatalk

trying this from phone Sent from my SM-G900I using Tapatalk

Ps couldn't see your pics for some reason Sent from my SM-G900I using Tapatalk

Thank you for your time I'll crank the heat up and plansh at after each dot thank you mark Sent from my SM-G900I using Tapatalk

hopefully this works thank you for your time

so is this undercut around the weld i have the same problem thanx mark

hi great work you do being reading your posts for along time just a quick question the low spots around the weld on bottom of gaurd is that a haz zone or undercut thank you mark