Recent content by ChrisBrooks

I used Kemiko stain then their sealer. It's holding up very well at the shop door where it gets the evening sun. The coca stain shows, but the sealer doesn't present any darkening, etc.

If you don't mind, I'd like to add my two cents. I bought the epoxy gray, but elected to use Kemiko Acid Stain, then the the sealer. The good thing about this is you can add sealer over-and-over to get depth and waxing can avoid scratching. You will never lift the stain from the cement. You...

Based on your electrical with welder, a/c, water header, etc., you need 4 220s and do not go under a 200 amp panel. For your lights, I have in my 38/50 shop 20 4' double strip lights on one switch with a 10 amp breaker. Insulation, if you go with a metal (as suggested above), look for a...

I have a 50x28. One side is OSB(Not painted), and the other side is Sheetrock(not finished). I'm going over both with a 4x8 very thin beadboard, then tin and keep repeating that on the entire wall. I just added a newbee entry to see if someone had any photos of what I'm attempting to do. I...

Great board everyone. Chris Brooks here from Macon Ga. I built a 50x28 shop with rooms on one side. One wall is sheetrock. The other is partical. Both look bad. What I want to do is use thin beadborad 4x8 then roof tin/beadboard again, etc. Ceilings are 10'. I'll stop at 8' then box in...