Recent content by chromedom

Thanks for the quick replies and the offer of help. If I need a rebuild I'll look you up. Thanks, Dave

Want to see if a rebuild kit is available for this jack? No numbers are apparent. Seller says it's a 1 1/2 ton Thanks, Dave

Well the leak ended up being the front seal. Not a bad job, just tough rolling it around to remove the bolts and clips. Also the nuts on the shafts were way to tight and now lifts very well. Thanks for your help and I'm now going to do my 2 1/2 ton Craftsman. Hey Hiball if you would I could...

Hi, Working on a Craftsman 2 1/2 Floor jack model #214.12114 couldn't find a serial number. Want to get a rebuild kit which I'm finding out is quite imposable. Gave the numbers to Lazzards with no reply yet. Anyone know where I can get them? Thanks, Dave

Wanted to replace some key seals because it looks like no service has been done. Only have a small leak i think at the release Valve. You think it's better just to go after the small leak and leave the rest until problems come up? I guess if it's not broke don't fix it! Dave

You think I can use the excellent post you did "Overseas Jack Rebuild Help Tutorial" to work on this jack??? As far as checking the seals?

Thanks for the quick reply! Read a lot of your posts thanks for the info from them. Very interested in getting the correct wheels for it. Is the oil fill the one closest to the (what I think is) reservoir sort of on a slant? Dave

Hi, I'm new to this site and found a lot of good information here. Seen many that are close to my model but not quite. It's a 4 ton, have the TM 9-4910-701-14&P manual but doesn't explain all the screws on the cylinder and what they are for. The paint is pretty thick so the markings are...