Recent content by cjc2160

To the op, I purchased and installed the same Takagi 120,000 btu unit you are looking at. It's only been running a month or so but it hasn't missed a beat, i am heating over 1900 sq'. Time will tell.

If I did it over again I would staple the pex to the foam, less labor. A boiler was out of the question due to cost, I realize the efficency is better but could not justify it, it's a barn. The manifold does not have actuators on it, all manual. Two zones with two pumps.

Going to bring this one back because its my turn. 40X48 pole barn, 12' x 40' room with bathroom. 2 zones one for room and other for shop. Just under 1900 foot of pex, 1.5" of eps foam under concrete and 3" around perimeter, heating with a Takagi T-H3M-DV-N natural gas. Fired it up last week to...

A Crapper and pex in the floor. Hows that for a first post.