Recent content by Cjreyes0101

Recently found one near me... http://losangeles.craigslist.org/sgv/tls/3706694802.html

I believe that is the Tool Caddy knock off. I think it's made in China or Japan... Great price though...

I got this Milwaukee M18 set last month along with an M18 hammer drill. Love them so far!

Found this at a the Pomona Car show/ Swapmeet today. Not bad for only $5. Can anyone tell me an approximate year this thing was made?

I found this hammer in one of my dad's boxes.

Thanks Eddie, I'll look into rustoleum's hammer finish!

Does anyone know of a paint to match the grey and red of these older craftsman boxes? I would prefer to use a spray can, and would like to get it as close as possible. Thanks in advance for any advice. -Chris

Thank You Sir, I actually talked the guy down from $100.:rocker:

Thanks! That's my first You **** here on GJ!

Thanks! Took a look at it, looks like 1070. So I'm guessing October 1970?

I finally have something to contribute to this thread! My new to me Craftsman box! Picked it up at a swapmeet for $70. I think I did good, just a little surface rust, not sure if to use it as it is or try and restore it.

Once lost my favorite 1/4 dr ratchet while working on my interior. Drove me crazy for about 6 months until I found it in my dashboard...

I like the gearwrench set. Got the 3/8 and 1/4 set at sears for $30 last month.

Yeah, I use the Gearwrench flex heads more than anything else in that drawer.

Here are my screwdrivers. Nothing special, but all made in the USA.