Recent content by ckeboss

  1. C

    "Budget" Single Phase 5HP Compressor Motor ?

    Weg
  2. C

    New Astro TurboStep Drill Bit Sets, 29pc & 21pc

    @Astro_Pneumatic_Tools Any comments of thoughts on the difference between the Astro and Norseman 22903 version?
  3. C

    concrete tools

    I have a 212cc wen plate compactor, works great. Only complaint is the paint wasn't very good, but that is minor. As for mixer, I also researched a bunch of mixers, and narrowed it down to you really want to find one with a 3/4 hp motor. All of the box store ones have a 1/2 hp motor which...
  4. C

    Show your new tool arrivals

    I have been looking for the 68100 tool, where did you find one? It looks like it has been discontinued.
  5. C

    SMALL compressor

    I am a fan of this form factor for the in between size from pancake to large stationary: https://www.homedepot.com/p/DEWALT-4-5-Gal-Portable-Electric-Air-Compressor-D55146/302918609 Everyone seems to make one similar.
  6. C

    Gasket markers: optimum better then ultra?

    I know one big difference is the solvent used. The Three Bond 1207b uses acetone, and most of the Permatex products I have used use oxime.
  7. C

    Gasket markers: optimum better then ultra?

    The products that Three Bond makes, which Toyota and Honda spec, are really good. The 1207b is pretty general purpose. I would say much better than the Permatex offerings. The Toyota part number for it is 00295-00103. I attached a little application guide Toyota has, but Three Bond does make...
  8. C

    Leak Down tester recomendations

    I have the Lang, many people rebranded it, including Snap-on.
  9. C

    Best Honda Toyota terminal depin tool set?

    The A/F connector is a Sumitomo HW sealed series connector. I did look at the catalog, and I do not see a specific tool that Sumitomo distributes for that series of connector, but being a Japanese company, perhaps its there, but I can't find it. To be fair, the Toyota manual does give you exact...
  10. C

    Gotta be a faster way to clean tools - especially sockets!

    I believe a dishwasher would probably work well too.
  11. C

    Gotta be a faster way to clean tools - especially sockets!

    For things that fit, the ultrasonic cleaner works well to remove the grease from everything. Not "Quick", but minimal labor.
  12. C

    Info on older Hoffman tire changer

    Looks like a rebranded Corghi perhaps? Most of that design are the same, all made in Italy.
  13. C

    Grinder plugged into 240V, fixable?

    So someone wired a NEMA 5-15 socket with 2 hot legs?
  14. C

    Autel Scanner Advice

    You have to understand the difference between "programming" tpms and registering. Most bidirectional scan tool will register TPMS, you must enter in the ID of the sensor. You will need a tool to read the ID from the sensor, of physically inspect the sensor to find the ID code printed on it...
  15. C

    Kellogg American air compressor restoration, need help!

    Did you take it to an auto body shop? I love how they even painted the air filter housing with metallic. Do you know if they used 2k clear on it all?
See more
Top Bottom