Recent content by ckeggs

For most automotive needs 3000psi is more than adequate, if you will rolling heavy dense equipment on the floor 4000psi would be a little better. The difference is 94lbs of cement (1 sack) between the two. A little trick to "encourage" the ready mix company to send a good mix is to request...

I am not familiar with the Sparta brand but I do use Increte brand stains for our decorative concrete work and have had good success. http://www.increte.com

Here is a link to a very good explanation of the "F" number which places a numerical value on both the flatness (variation from highest to lowest point over a given range) and levelness (slope over a given range). As stated earlier as the requirement for flat floor increases so does the labor...