Recent content by Clarke33

I'm a pro and have a, first year manufactured, Dewalt DW708. I have cut a gazillion feet of trim and it is still accurate and runs like a champ. I have replaced brushes a couple of times and rebuilt the electric motor earlier this year. The parts were around $50. As far as I am concerned the...

Good luck finding much info. I have an older Wayne and have looked and looked but have found very little. On the plus side it was given to me if I would haul it off. I spent $5 on a start capicitor and it still works like a champ.

I checked the Ammco/Coats site but they don't have any of the old manuals online. Usually I can find about anything online but this seems to be a challenge.

I have already checked Ebay. I know there was boat load of those old Ammco's in years past but there is virtually no info out there now.

I have searched high and low for a parts manual for my ancient Ammco 660 but have struck out everywhere I have looked. Anyone know anyone who might have info on these old machines. By the way, it still works pretty well breaking down tires but struggles some mounting them especially low profile...

Newbie here but let me throw in my 2 cents. As a contractor I usually tell customers there are 2 types of concrete. The two kinds? Concrete that has cracked and concrete that is getting ready to crack. We always compact the substrate, use expansion joint and steel but still sometimes it will...