Recent content by cma3169

Well said firebrick43 haha

Hey I've seen your thread before 😄. I think what you did should work in my garage

On the back end it's a wall and then on the front wall a ridge beam maybe could maybe be supported by the block column that is separating the 2 single garage door openings

Could this be made Into a vaulted ceiling

I just measured and it's only 4 foot from the bottom of the rafter ties to the top of the ridge board, so that's only a little over a foot higher. Just wish I could make it a little higher than that. Thanks

I ain't thought of that. Are you saying use bottle jacks and at what spot would I jack the roof up on the rafter ties?

Its 11 foot from the concrete floor to the top of the ridge board

Does this picture help? I'm having a hard time trying to post pictures

I have a 20x20 block garage and I'm wanting to raise the ceiling joists up about 3 feet to give me a higher ceiling. I would like to put ceiling joist/rafter tie where the tape measure is pointing or is there any other way to give me the highest ceiling possible without tearing down and building...