Recent content by cokeb5

  1. C

    Water leaking behind the gutter - please help

    Often that style of flashing is used when a new roof is installed without removing old shingles. Just my guess.
  2. C

    Another 55 F100 build-Long Term

    I'm planning on getting back to work on my 56 budget build and was curios what vehicle your swinging brake pedel came from? Craig sorry drew just found the answer in post #46
  3. C

    The Heavy Bench

    sorry didn't understand your question, plenty of drag between the parts but still lifts with little effort.
  4. C

    The Heavy Bench

    when I turn the 15/16 bolt head 90 degrees the cams shown in pic. Two push down on the wheels lifting the table, when I get to my destination turn bolt back and the table drops back on its legs
  5. C

    The Heavy Bench

    here are some pics. the 1" square tube acts as a guide for the round tube, the black pipe has a 5/8 bolt plug welded.
  6. C

    The Heavy Bench

    my bench has close to the same idea, the jacks are replaced by 1/2 black pipe running through the legs front to back with a cam located above each caster bolt, a 1/4 turn of the pipe and the bench is on its wheels
  7. C

    Nut & Bolt Storage

    Re: Nut & Bolt Storage I have that same cabinet, the small blue electrical boxes work great for small parts, just need to trim a little off the top and there only .18 each.
  8. C

    Garage soda fountain to match the kegerator?

    what type of system are you considering, pre mix or post mix?
  9. C

    Need Ideas For Retractable Casters On Steel Table

    a little hard to explain, my table lifts up and down via a cam system, the casters are mounted to 2x2 square tube between the legs with round tube welded verticaly to each end of the square tube, the round tube rides inside 1x1 square tube welded to the inside of each leg, the round tube is...
  10. C

    Caster recommendation for workbench

    I like casters on my work bench, though it sits against the wall most of the time its nice to roll it to the center of the shop and drop it down on its legs and have solid place to work.
  11. C

    Done with NAPA

    I have to say my local Napa store is great. I'm just diy guy not a big customer and they always call me by name as I enter, I have never had a bad experience with them. I will say the younger the employee the less they know, but I think that is the same any where, the guy that has worked there...
  12. C

    TOOLGAZAM!!!! UPS just showed up!!!

    is there shipping involved when ordering online vs. Going through the dealer?
  13. C

    FS: Gearwrench ratcheting wrench set

    I'll take them, PM sent.
  14. C

    SK, SnapOn, Thorsen, Williams, Craftsman

    Going to pass on the Snap On SW421 1 5/16" 12pt socket.
  15. C

    SK, SnapOn, Thorsen, Williams, Craftsman

    Snap On SW421 1 5/16" 12pt $13.00 shipped, PM sent.
See more
Top Bottom