Recent content by CommittotheIndian

Any reason spray over mineral wool insulation? I’m not completely opposed to it just not sure it’s something I want to attempt.

THANK YOU SO MUCH! I have read so much on this that it just jumps back and forth. One thread, forum, person, video says do this another says that. I did not get the floor insulated but I'm looking at the idea of ridged foam board under neath if I have enough gab to reach and install (not...

Thanks, I think I’m covered there. There are 18 outlets in here, 4 are just below the ceiling. I have an outlet in every other bay.

I do not have a ridge vent or soffit vents, just two gable vents. So would you worry about baffles in my situation? As others have said, I’m thinking I’ll have enough ventilation with the gable and door (plus no insulation for the floor).

100% more than likely. It is suggested my CNC not be stored in a space below 40F.

Just to make sure I'm following your response. The typical answer would be to continue the loft floors across to make one big closed attic? But your suggestion would be spray foaming the roof, no additional ventilation, vapor barrier concerns, etc?

I am in need of some advice and it looks like there are some knowledgeable individuals in this forum. I haven't quite found the answer that closely relates to my situation so I'd appreciate any response. I have a 10x16 smart barn with two 4 foot lofts and a metal roof. I plan to use this space...