Recent content by Concrete Homes

In our area, we do quite a bit of EZFloor-it is out of Wisconsin. It is EPS insulation and vapor barrier in one sheet. You can drive a laser screed over it. Holds the tubes, so no need for wire, chairs, etc. I think the website is EZFloor.com or something like that. I am in the Ready Mix...

You did not mention if you are going radiant or not. We carry one called EZ Floor out of Wisconsin. It is insulation, vapor barrier all in one, and has moulded in high spots to run your tubing in. That is made at the plant we get Fox ICF from in Post Falls, ID. We also have another one made...

That is a super clean Vega and a nice looking V-8 Swap. I sent this thread to my mechanic, who is from Niles. I was back there a couple years ago hauling some rust free El Camino doors back to a friend of his. He has been out west here for about ten years. I think it is cool the way you use...

No such thing as "too much Concrete"...:thumbup:

I also installed a Made in USA 10k lift to work on various cars, but since I have a Dodge Cummins, like your F 250, I went 10k too. Drill a test to be sure your concrete is nice and thick. When I first went to install it, the slab was only about 3.5", so I cut out about a 5' segment where the...

I did this in Minnesota. Had to did down the width of a shovel around foundation and dug out the footing as well. Pressure washed the Leaky CMU block, let it dry and applied Sonneborn HLM 5000, trowel grade. Covered with protection board, (I would use Eco-Drain Mat now) and did a 5" French...