Recent content by cosmic_kitchen

@DirtyV I can't comment on the effectiveness of the different designs, but out of the ones on amazon, those Garadry brand ones are on average 500000% more expensive as the other alternatives.. Some on there for a 20' door are only $35 while the Garadry is $135-300.. for a literal strip of rubber...

Thanks for the reply, I continued my research. I wasn't aware of the different types of sealers (negative side vs positive side) and had just always read that any sealer on a pad needed to be removed prior to epoxy going down. I ordered a couple jugs of Deep Seal

So I've now chatted with someone from Sales and someone from technical support at Armorpoxy, neither have heard of this product or were able to offer any information about its compatibility with the Armorpoxy products I have. From what I can read the Deep Seal is a water-based concrete sealer...

Awesome thanks for the response. I got a hold of someone at Armorpoxy that didn't have this information. They said they used to carry something that matched my description but no longer do. Despite my low results, I think I'd like to apply something like this as a safeguard. I think there is a...

Reviving this thread to provide my results. Out of three moisture tests two of them were 1-1.5 lbs/1000 sqft. One of them was 3.2 lbs/1000sqft. Going to try to call Armorpoxy today to see what this spray is all about and if they'd recommend anything. Hoping to get the floors done in the next two...

There is water that came through the door in the photo, and replacing/adding gaskets is definitely in the plan. But my concern are the moisture patches closer up in the photo. Those did not result from direct surface water. I’ve ordered the moisture tests and will run them a few times over the...

Unfortunately I did, but again, only coinciding with the rain.

Hey everyone, first post here but I’ve been reading through several threads in preparation to do an epoxy floor in my ~ 500sq ft attached garage. The house was built in 1988 and I’m located in Raleigh, NC. I ran the plastic square moisture test prior to ordering my product. All 5 squares were...