cpakalolo's latest activity
-
COther manufacturers specifically tell you to not drill all the way trough, because the breakout spalls a reverse cone at the bottom of...
-
Ccpakalolo replied to the thread Looking for 2 post lift recommendations.I have to agree to this too. Rebar is not always specified by the lift manufacturers. The difference is the size of the base. Look at...
-
Ccpakalolo replied to the thread Looking for 2 post lift recommendations.If you get a four post, realize they cost more and to use them you will be getting bridge jacks that are expensive. I have a bad back...
-
Ccpakalolo replied to the thread Looking for 2 post lift recommendations.I asked every salesman I could get a hold of to ask the question of whether symmetric or asymmetric is better for trucks etc... and I...
-
Ccpakalolo replied to the thread Cast Iron to PVC union, Plumbers what am i looking at here?.Last Summer I was talking someone on the phone through one of these joints. I did it previously in 1979 and the homeowner was finally...
-
Ccpakalolo replied to the thread Any Long Lasting garage door openers?.I would definitely get a belt drive if I got a regular opener. They are so quiet.
-
Ccpakalolo replied to the thread Looking for small drive screws or rivets with large heads ??.Thank you
-
Ccpakalolo replied to the thread wow diamond blades don't last long.Might be the blade. I have a blade that I have been using to cut concrete and stone for years. It was a couple hundred bucks and I...
-
Ccpakalolo replied to the thread Any Long Lasting garage door openers?.Jack shaft openers have their problems. They don't push down on the door, so they need a deadbolt. Only the newest models can monitor...
-
Ccpakalolo replied to the thread Looking for 2 post lift recommendations.Some of these lifts are so wide, that opening a two door is easy to do.
-
Ccpakalolo replied to the thread Looking for 2 post lift recommendations.You say you want symmetric. Don't limit yourself. You might want a bi-symmetric. I just got an asymmetric Tuxedo 11 k, TP-11 KC-DX...
-
Ccpakalolo reacted to wyliesdiesels's post in the thread it's quite common that people to think you need 3 wire plus ground for 240 volts with
Like.
where is this adapter posted? its a really dumb design since the 6-50 doesnt have a neutral. as CGT80 stated, i would check the j box... -
Ccpakalolo replied to the thread Cordless 1/4" hex power drivers - your screwdriver and impact driver lineup.Wow! I literally can shop from that one picture for a new one to replace my old Skill Twist.
-
Ccpakalolo replied to the thread Cordless 1/4" hex power drivers - your screwdriver and impact driver lineup.If you find a good one let me know. I have owned them over the years. The best was a 3.8 volt Skill Twist. Not the best battery, but...
-
Ccpakalolo replied to the thread Looking for small drive screws or rivets with large heads ??.I use regular aluminum rivets that you just hit with a hammer. You drill the hole, drop the rivet in and pound until good. They are solid.