Recent content by crlogan

NitroPress, How much of a gap were you able to get yours down to?

I've been playing around with these. http://www.alwitco.com/alwitco/our-products/atomuffler-series/air-exhaust-muffler.html. First tried the M05 and it's worked pretty well. You can find them on eBay for around $20.

I've got a BendPak HD-9XW. When I lower it (this is with nothing on it) it sits about an inch high off the metal base of the 4 columns. I've tried adjusting cables but in order to not have sloppy slack and keep things pulling level I can't get it any lower. Is this normal? The only reason I...

I bought the set of 3 a week ago. I haven't put them through a rigorous test yet but my initial test with them I found them fantastic to work with. They are spendy but after getting them in my hands I think they were worth the cost.

My 60 gallon Quincy air compressor is equipped with an auto drain. Any of you that have worked with an auto drain before know having the loud blast occur every so often can be annoying or scare you if you're not used to it. Has anyone found a good solution to muffle or silence an auto drain...

My floor has a nice epoxy finish as well. I am looking for rubber pads like you made to use on all 4 posts. Where were you able to obtain that material?