Recent content by CuriousG

If you pay attention to your cuts it looks fine. A laminate floor cutter is a lot cleaner than a saw.

You can rent a laminate cutter from Home Depot. So much easier.

Both were made by Waterloo I thought

I am not sure I understand the “changed hands so many times” comment. The brand changed hands once. Do you mean the contracted manufacturing?

Long time lurker who has been inspired by many on this forum. I finally bit the bullet and bought my Racedeck floor. While preparing to put it down, I noticed I have a dip/recessed portion ahead of the door (i.e. the door sits lower than the rest of the floor). I am assuming in this case I would...

Looks great! What kind of gap did you use with the free flow? I have an all free flow floor on the way (ordered yesterday) and thinking about how it will actually end up. I am doing a border a couple tiles in but realize to get it centered I am going to likely be cutting both sides unfortunately/

The best/most versatile option would be a Z-Wave hub like SmartThings (now made by Aeotec) or Habitat hardwired (I assume you still have internet?) and a Z-wave sensor. I used a cheap sensor from Monoprice that is still on its first battery 3 years later.

That looks awesome!

I have been grappling with the same thing. I am planning free-flow, and think solid looks fine - but feel "boring". Do agree that full checker can be a little much. I think a good compromise is a simple border set a couple feet from each side (obsessed garage style).

Hello all, I finally have moved into a home with a decent garage and stumbled across this forum/site while doing some research on a potential epoxy floor project. I must say this is a great community and I am pleased to have signed up. -Curious