Recent content by Dakar652

i've got a gear driver kit, very similar, although somewhat more extensive than the set you have, and for some reason my ratcheting screwdriver works to both loosen and tighten. my gearwrench gear driver actually looks IDENTICAL to the new snap on model and works just as well. this isn't true...

i had actually been considering the OTC puller for quite some time. i just wasn't crazy about that extra step you have to take to use the OTC. I guess the snap on puller is really my only choice with time being of a major factor. i work at a junkyard, and i now need to keep my core power...

i'm not sure if this is the same one that does vacuum pulleys or not...but i already have a KD kit, and it's just too much effort to remove a pulley with it. i guess i'm going to end up paying the money for the snap on if there is nothing comprable...thanks for all your replies!!!

i should add that these are TOTALLY ILLEGAL in MASSACHUSETTS!!!:rocker:

AHA AHA HAHA ...why would I have four flat tires, when i could just take the air from some unsuspecting old lady parked in the handicapp zone at the grocery store... actually, i have one of these professionally made up with rubber airline and two indusrial tire chucks at each end...the...

Look, any reputable tool salesman will not sell you a tool unless you can just return it with "NO QUESTIONS ASKED". With this said, you should not need to keep your tool receipts for warranty reasons, unless they're electric, gas, air, or otherwise powered tools...but for reasons dealing with...

i've been weighing the decision and i really can't seem to come up with a better puller than the Snap On made kit (which now includes the installer for the rather outrageous price of $240)...I ordered the kit through my Snap On guy, but i'm trying to figure out my options before i actually start...