Recent content by damndirtyape

I've read about people bolting boxes on but that just seems like it wouldn't be a sturdy has having the lip. compressive tension vs shearing the sides. Maybe some fender washers and do like 4 or 6 bolts and it'd be good? Not that I plan on storing cement in the side boxes but I do prefer to...

I may do that just to see what info they can give. Thanks so much for your help! Fabbing something up might work, bend up some thick steel to go under the insert, up and around the top and then have a lip to hang off...

not my pic, my box is offsite and don't have any handy but this shows what I'm talking about. Hijacked from another thread here. The lips at the top are the same width as the aluminum trim pieces that run vertically. Honestly if that top wasn't recessed, there wouldnt be a lip at all.

Yes it does but the lip would have to be a good 3/4 to 1" wide to grab on. Maybe snap on lockers are wide enough but the Matcos I was going to buy had a small rolled over lip. They'd probably hang off my craftsman roller but not the Snappy. Is that the case?

Hi all, Every search for information leads to this board so had to join up and I have a couple questions. I recently inherited my fathers Snap On KR560 from '86 according to the back. I was going to add on some Matco side lockers I found CL on the cheap but when I went to look at my box, it...