danielbuck's latest activity

My latest project. Other than the four hinges on the doors, there are no metal fasteners holding this cabinet together. Jim C.

I have a small hand held Chapin, and a backpack Chapin, I like their quality. as for leaking, they aren't really meant to be set up on...

come on man, saw-zall.

that's a shame :confused: I would have hoped they had better customer service than that. :headshake

At least bring some flowers.

that's what I was getting at, it will stay pressurized basically indefinitely sitting on the shelf, and you won't need to re-pressurize...

sure-shot is fantastic for solvents. pressurize it with compressed air, or even a bicycle pump if you don't have that. It does use a...

it'll just rust, that's it. Same with welding aluminized tubing, it'll rust where you weld.

eh... not sure that's a fantastic analogy, I've never seen a vehicle get better MPG with higher octane fuels. Unless maybe you're...

are you just cutting out and replacing a 4" straight section? You probably don't need to tack weld it on the vehicle. Just mark a...

It's exactly why I bought one a few years ago. Careful though cause the garage can go from looking like this to this just a few...

I mostly work with tube, angle and flat bar instead of plate, so for me a plasma cutter isn't something I use a lot. It's great for...

Just posting this here since I asked earlier. The 1/2" step bit worked extremely well through various thickness of steel. I will be...

I like using deep sockets because once the nut is free, (if I'm not using air or impact) I find it easier to spin the nut off the rest...

I suppose one last thing worth noting. I've always found that if you are nice and polite when contacting support, you're more likely to...