Recent content by dasgreasyshrimper

Thank you for the information. I would have thought other manufacturers of wheel pullers would have shown up in my searches of wheel pullers but they didn't. There were none listed on Ebay.

Thanks for the information. Do you know if BOG stamped the model number on any of their pullers? Mine has 3 stars but nothing other than the shaft size.

Oliver, I suspect your lid will rust again on the rim fairly quickly because you were unable to remove all the pits and therefore all the rust. I would suggest sandblasting to clean the rust out of the pits and powder coating to create a smoother, harder surface.

I have a BOG "Drive-Out" Wheel Puller that I believe was made for a special order because it is a size (13/16" - 16?) not listed on the BOG catalog page I have. All the pullers shown on the catalog page are in increments of 1/8th inch. I suspect this tool was made for a prototype or race car...