Recent content by Dave's

I had the same problem. Sounds like the Campbell Hausfeld VT series. Same number casted on my crankshat VT-6

I've been rebuilding jacks and cyls since the early 80's. Must be you do to. Good job! I've got a place where i can get just about every metric cup or seal. Any problems give me a shout.

I've been rebuilding jacks and cyls since the early 80's. Must be you do to. Good job! I've got a place where i can get just about every metric cup or seal. Any problems give me a shout.

I've been to the Mont. Ward page To NOTHING

If you would fax everythng to me i'd be grateful. Any info is better than none. Bye the way i found out that the Campbell Hausfeld model number is VT-4068 I'll send you a private with my phone# Thanks Again

The one number on my crankshaft is VT-6. This is simalar in respect! Dave's

I can give you casting numbers off of the crank and connecting rod if that will do for now. Numbers on connecting rod are VT-1-B and on the crank are VT-6 , UF-1 , 332 - 2 and 672 Number on housing of pump V shaped cooling finns. Would this be an old Campbell Hausfeld VT...

Hi, I have an old Montgomery Ward air compressor model XER6408 and serial#06182H-936786. It's a 5hp, 220volt, twin cyl, 12 gallon tank. I need a crankshaft and one connecting rod, and gasket set for it. Does anyone know who made the compressor for it and where i can get parts for it. I bought it...