DAWrench's latest activity

Those sizes are way to big for an impact driver. 12 mm is probably about where I change to the 3/8 impact and swivel sockets

No experience with those but I just use a 1/4 wobble bit driver with regular sockets for my impact driver. It works fine for small low...

Honestly, with a 7.5HP Emax and an 80 to 120-gallon main tank, you’ve already got a massive amount of volume at the source. With 3/4"...

I added a small 20 gallon tank on the far end of my shop away from the compressor. Only about 50' from the compressor. I feel like it...

Fork mounted for ssqa mounted forks or a fork lift. A euro pattern quick attach platform that is elevated. Direct to SSQA Lots...

I would rent a scissor lift or scaffolding to do the initial work you need to do. After that it's hard to beat a compact tractor with QA...

I didn't read this closely enough You aren't building the building yourself, right? A 14' height is reachable with an 8' step...

It is the same story with most of these "warranty" discussions - just do your best not to break tools. I use ratcheting box wrenches on...

Slightly oversize holes on 3pt equipment are your friend. A little slack doesn't hurt and makes getting the pins in WAY easier!!!

Using sockets with a shop press is not recommended because when you look at the specific details in the drawings of the socket and...

The answer is yes but the difference should be inconsequential. Impact sockets exist because impact wrenches wallow out normal sockets...

Either one is fine. Biggest use for my 3/4 drive chrome sockets