Recent content by dbul

I found these at Tractor Supply for $22,made in USA no less..5.5 gallon,wide mouth….

2018 isn’t new…Just trying to save someone a disaster…

Be careful using cooking oil containers.They will eventually become brittle and disintegrate just when you least expect it….

This is my Reed #105 that was given to me by an older gentleman some 40 years ago. I had just opened a small repair shop and had purchased a humongous flea market vice.While installing u-joints in his Datsun, I tapped the jaw of my bargain vise and low and behold the whole jaw broke off and hit...

Thanks Wamsutta!It looks like I've got the full SAE set and a long way to go on the metrics.

Ha! When those cute little girls come around,just tell them I owe you a box.If and when you do get to the bottom of that stack,please check.I will probably never use these,but they sure are nice to look at!

Does anyone know what sizes were available in the Micro Turn series? I have 15 SAE wrenches (1/4"-1") and the 10-11-12-13-14-15-19 metrics.Other than the obvious 16-17-18 mm ,what other sizes were available?I first used one of these(18mm) to remove the inboard calipers on an XJ-6 back around...