Recent content by demolitionman

My Lowes sells Wilde USA tools.

I fully agree if your setting up airlines for the longhaul, copper is the only way to go. My rusted to hell lines were off a 60gal single stage Compressor thats seen light weekend use for the last 8 years. I also think it's very important now to drain the water back into the tank for the first...

do husky sockets have the Same detent as Cman inside the drive square?

I pulled a few fittings off my air lines last week and the suckers had chunks of rust! It was horrific. I had no idea it got that bad. The closer to the tank the worse it got. Black Pipe and I had a cheapo water filter too close to the tank to do any good. My fault but wow I'm a believer in...

I didn't have time to read the whole thread; I got this out of what I did read; house is old, needs demolished, your looking for info on route to take. Don't bother trying to burn; one its way way more work than youd imagine, and two, SOME, states construction and demo landfills will not take...

No, but I use the smaller 2 sized square recessed that wood screws have in a 1/4 hex driver.

I'm pretty sure the Tekton Reel is just a rebadged Michigan Industrial Tools reel. Fwiw. I'm going to go get a 3/8 reel today myself and am wondering if I should go to Rural King or go to Andersons(sells the Tekton reel for 89.00). Heard rural King has the Goodyear reels. Anyone know if this...

Seriously? My. coworker went to the ER yesterday for metal shards in his eye! He had glasses on too. I've been twice in the last year from sledge hammer related eye intrusions, of which one time the doc had to stick a NEEDLE into my to remove the metal. Ugh, I'm so cautious of my eyes, I wear...

In my experience, a drill driver typically has less chuck runout than a hammer drill, so if Your using it on metal a lot it's been my experience non hammering drill drivers typically have a truer shank. Doesn't much matter on wood IMO. Anyone else experience the same?

Thanks. I'll pick some up tonight.

Well gang I got the Milwaukee fuel 18 kit hammer drill and 1/4 hex impact. Ended up having to take the first kit back, but the replacement was great as was HD's customer service. Can you say Beast of a cordless tool? :) Now to find the absolute strongest 3/8 adapters made.

Get a 346xp. Leave it stock, buy a tach and tune it to run around 12,300 rpm's. Bad bad bad little saw. Nimble and will make quick work of Majority of stuff.

full fleet of pre-emission XP's ported and brazed exhausts. 346,372,390. Started running XP's and sold every pro stihl I had except the tree ms200t saw.

err, I miss typed the title! Child Chimney Sweeps.I came across this article that I found both fascinating and cruel. I've burn wood, coal and pellets my whole life and have delt with chimney fires, clogged chimneys, creosote issues, critters living in liners and squirrels stuck in clean outs...

I'm with you. A speed square and 7 or 8 amp 4.5" angle grinder that way you don't have to lift a lot of heavy steel to the tool rather you take the tool to the steel. Also, a trick that I use is when fitting up, or setting your joints; tack'em withe the welder really hot then quickly before...