Recent content by Dentmanaustin

I have used Sherwin Williams DTM (direct to metal) on a metal roll up door. Pressure washed door and applied, been on over a yr and gets sun all day no problems.

Here's a pic of metal in my shop just finished this winter

just wanted to say thanks for the input and advise, I knew this would be the place to ask.

The 2 I'm looking at are Falcon. Model # are 10000 for gas and 8000 for diesel. I will be using them for general use around shop and farm. List prices are 1990.00 for gas and 6890 for diesel. I could get gas for 1500 and diesel for 5000. I don't mind either price I just want to make the right...

Just trying to find out which is better gas 10000 or diesel 8000

thanks for the advise I will ck with them and see

I recently poured a 3750 sq foot slab and wanted a nice slick finish, which I did get. I then asked contractor which sealer to use and he told me to call rental store they could help me with that. So when I got there they suggested a cure and seal product with 2 coats. To make a long story...

What about trick my truck those guys look like they know what their doing

Hello all, have been reading and learning a lot lately. My question is about capping a slab that is already 6 inches thick but unlevel. Looks like several buildings were there before shop was built. My shop is a 50x75x25. It was used as a trailer building shop. What type of mix and how thick...

I just bought used 6 bulb mirrored fixters and when I had to replace the ballast because of the rating on ballast I talked to my friend in the lighting world and he explained it to me like this, there are 3 different ballast you can buy. A low ballast factor with a .55 rating, standard ballast...